SKC DatraTrac 2000 for the AirChek 2000_3000 - Manual (Page 5)

3
Installation of Software Update (previous version exists on PC)
1. Close all applications.
2. Insert DataTrac Soft ware CD into CD-ROM drive. The CD is set up to autoplay.
If it does not autoplay on your PC, go to Step 2a.
a. Click Start butt on on tool bar.
b. Click on My Computer.
c.
Double-click CD Drive.
d. Double-click Setup.exe.
3. The IS Welcome window will display.
a. Click Next.
4. The IS Program Maintenance window will display. Three options will appear:
• Modify - used to change sett ings aft er installation
• Repair - used to update previously installed soft ware and to repair installation
errors
• Remove - used to remove the previously installed version of the soft ware
from the hard drive (SKC recommended).
a. Click Remove.
b. Click Next.
c. The IS Remove the Program window will display.
d. Click Remove.
e. The IS Uninstalling AirChek 2000 window will display.
f. The IS Wizard Completed window will display, indicating successful
removal of the existing soft ware.
g. Click Finish to exit the IS Wizard.
5. Follow instructions for Installation of New Soft ware.
Complete DataTrac 2000 Soft ware features are only available when an active
sample pump is connected to the PC (see Connecting the Pump to a PC). The
SKC DataTrac Pump Manager window may be accessed without a pump
connected to the PC; however, only limited features will be available (see
Connecting the Pump to a PC, Connection Error Box, Figure 2B on page 6).
DataTrac 2000 Setup