LiftMaster LA500 Residential / Light Commercial Swing Gate Operator - Manual (Page 33)

31
LIFTMASTER INTERNET GATEWAY
To program the operator to the LiftMaster Internet Gateway:
USING THE LEARN BUTTON ON THE OPERATOR’S
CONTROL BOARD
1
Connect the ethernet cable to the LiftMaster Internet Gateway and the router.
2
Connect power to the LiftMaster Internet Gateway.
3
Create an online account by visiting www.myliftmaster.com.
4
Register the LiftMaster Internet Gateway.
5
Use an internet enabled computer or smartphone to add devices. The LiftMaster
Internet Gateway will stay in learn mode for three minutes.
6
Press the Learn button twice on the primary operator (the operator will beep as
it enters learn mode). The LiftMaster Internet Gateway will pair to the operator
if it is within range and the operator will beep if programming is successful.
OR
USING THE RESET BUTTON ON THE OPERATOR
1
Connect the ethernet cable to the LiftMaster Internet Gateway and the router.
2
Connect power to the LiftMaster Internet Gateway.
3
Create an online account by visiting www.myliftmaster.com.
4
Register the LiftMaster Internet Gateway.
5
Use an internet enabled computer or smartphone to add devices. The LiftMaster
Internet Gateway will stay in learn mode for three minutes.
6
Ensure gate is closed.
7
Give the operator an OPEN command.
8
Within 30 seconds, when the gate is at the open limit press and release the
reset button 3 times (on primary gate) to put primary operator into High Band
Learn Mode (the operator will beep as it enters learn mode). The LiftMaster
Internet Gateway will pair to the operator if it is within range and the operator
will beep if programming is successful.
The status as shown by the LiftMaster Internet Gateway app will be either “open” or
“closed”. The gate operator can then be controlled through the LiftMaster Internet
Gateway app.
LIFTMASTER INTERNET GATEWAY
ADDITIONAL FEATURES