Teledyne LeCroy WaveStation 3000 Operators Manual - Manual (Page 15)

Operator's Manual
Frequency or Period, but not both.The first press of the softkey button selects the top parameter, which is then
highlighted in blue; the second press selects the bottom.
These dual parameter options have two different colored backgrounds, one lighter and one darker, to keep
them distinct. Selected parameters will show the lighter shading (when they are not active and blue), and
you'll notice that these are the parameters you see in the Parameter Value List. You may sometimes notice
that when you select one dual parameter, the shading changes over other dual parameters. This indicates
parameters that must be configured together. For example, Amplitude and Offset, or HighLevel and LowLevel.
L ABELED M ENU O PTIONS
Some menu options appear to be dual parameters, but actually the top part of the option is a label, while the
bottom shows the selected value. When configuring waveforms, this usually indicates the selection was made
on a previous menu, but is made available again in case you decide to change it. For example, when you
display Modulation parameters, the Type option shows the selection made on the previous Modulation type
menu. You need only press the softkey for these menu options if you now wish to change the selection.
A DDITIONAL M ENUS
Menus that have a More at the end have additional pages of options. Press the softkey button to go to the next
or previous page.
922869 Rev B 9