Teledyne LeCroy WaveStation 3000 Operators Manual - Manual (Page 35)

Operator's Manual
Power On Setting
The WaveStation default is to revert to the factory settings after power down. To retain the last saved settings
and restore them at power on:
1. Press the Utility function button.
2. Press the More softkey, then press System.
3. Press PowerOn until Last is selected.
4. Press More, then press Done.
Sound
The WaveStation default is to emit a low beep whenever a control is pressed. To turn off the sound:
1. Press the Utility function button.
2. Press the More softkey, then press System.
3. Press the Beep softkey until Off is selected.
4. Press More, then press Done.
Screen Saver
The WaveStation is set to turn off the LCD if there is no activity for 15 minutes. To change this setting:
1. Press the Utility function button.
2. Press the More softkey, then press System.
3. Press More, then press ScrnSvr.
4. Choose another time out value from the menu, or Off to disable this feature.
5. Press Cancel to return to the previous menu, then press Done.
NOTE: Only the LCD is disabled after the time out to preserve the display. The WaveStation continues to run
and generate waveforms.
Clock Source
By default, WaveStation utilizes an internal 10 MHz reference clock. You can choose to instead input an
external reference clock. To change the reference clock:
1. Connect the clock to the 10 MHz Input connector on the Back Panel.
2. Press the Utility function button.
3. Press the More softkey, then press System.
4. Press More, then press CLKSourceuntil External is selected.
5. Press Done.
922869 Rev B 29