Teledyne LeCroy WaveStation 3000 Operators Manual - Manual (Page 16)

WaveStation 3000 Function and Arbitrary Waveform Generator
D ONE A ND C ANCEL
Some option menus, such as Utilities, go several levels deep. In this case, you may see a Done or Cancel
option at the end of the menu. The procedures in this manual explain their use in specific situations, which
may vary slightly menu to menu.
Parameter Value List
The right side of the display is a detailed list of numeric parameter values. This area is used to adjust the
parameter.
Adjusting Parameters
Once a numeric parameter has been selected from an option menu, it is activated for editing on the
Parameter Value list. You can adjust the value using either the front panel Adjustment knob or the numeric
keypad.
Using the Adjustment Knob
This is perhaps the easiest way to both select and adjust parameters when configuring waveforms.
1. Select the first parameter from the menu using the softkey button.The parameter will appear blue on the
option menu and white on the Parameter Value list.
2. Use the Left/Right Cursor buttons to select the digit to change. The selected digit is highlighted blue.
3. Turn the Adjustment knob to raise or lower the value of the digit.
4. Repeat Steps 2 and 3 until all digits are adjusted.
5. Press the Adjustment knob to save the setting and activate the next parameter on the list.
The Adjustment knob is also used to navigate and select from the Built-in Arbitrary waveform menus . In
general, if a selection is highlighted white on the display, it can be controlled using the Adjustment knob.
10 922869 Rev B