Teledyne LeCroy WaveStation 3000 Operators Manual - Manual (Page 40)

WaveStation 3000 Function and Arbitrary Waveform Generator
Connecting WaveStation to the PC
To re-establish the link between the WaveStation and your PC after the initial software installation:
1. Power on WaveStation.
2. With the PC turned on, connect the USB Type B-A cable from the rear USB B port on the WaveStation to a
USB A port on the PC.
3. Launch the WaveStation PC software.
Reading Files from WaveStation on a PC
You can retrieve any stored or arbitrary waveform file from the WaveStation and send it to the WaveStation
PC software for modification.
Complete the preliminary steps to:
l
Install WaveStation PC drivers and software.
l
Make the connection from WaveStation to the PC.
Starting from WaveStation
1. Follow the steps to generate an arbitrary waveform , choosing either one of the Built-In or Stored Wforms.
2. In the WaveStation PC Software, choose Communication → Read wave from the menu bar.
3. Select the device you want to read the wave from the Device List. The software detects multiple devices.
4. Select the stored or built-in waveform from the Wave List. You will see all the wave files stored on the
device.
34 922869 Rev B