Teledyne LeCroy WaveStation 3000 Operators Manual - Manual (Page 32)

WaveStation 3000 Function and Arbitrary Waveform Generator
When you first press the Save softkey during the Save procedure, the keyboard is displayed with the default
File Name shown at the top. To change the name:
1. Press the Delete softkey to clear characters from the File Name field.
2. Use the Adjust knob and the Up and Down softkeys to navigate to characters on the keyboard.
3. When the desired character is selected, press the Select softkey to insert it in the File Name field.
4. Repeat until you have entered the desired File Name, then press the Save softkey.
Save/Recall Setups
1. If saving to (or recalling from) a USB drive, insert the drive into the USB host port on the front of the
WaveStation.
2. Press the Utility function button, then press the Store/Recall softkey.
3. Press the FileType softkey until State is selected.
4. WaveStation defaults to the Local (C:) folder. If using an external drive, press the Browser softkey until
Directory is selected, then turn the Adjust knob until USB Device is selected. Otherwise, skip this step.
5. Press the Browser softkey to select File. The cursor switches to the file list at the right side of the dis-
play.
6. If using internal storage, turn the Adjust knob to select the desired STATE memory bank (1-10).
NOTE: Any prior data stored in an internal memory will be overwritten when you save. If possible, select a
State that does not already have a setup file associated with it.
7. To save the current setup:
l
Press the Save softkey.
l
If desired, use the keyboard to change the default File Name.
To restore the WaveStation to the selected setup, press Recall.
26 922869 Rev B