Restoring the default settings, Restoring default settings – Teledyne LeCroy WaveStation 3000 Operators Manual User Manual
Page 36
WaveStation 3000 Function and Arbitrary Waveform Generator
Restoring the Default Settings
To restore the WaveStation to the factory default settings (shown in the table below):
1. Press the Utility function button.
2. Press the More softkey, then press System.
3. Press Set to Default. After a moment, the screen will blink and reset to the CH1:Sine wave parameter
menu.
SubSystem & Parameter
Default Values
Output
Function
Sine Wave
Frequency
1 kHz
Amplitude/Offset
100 mVpp/0 V DC
Phase
0°
Terminals
High Z
Modulation
Carrier
1 kHz Sine Wave
Modulating
100 Hz Sine Wave
AM Depth
100%
FM Deviation
500 Hz
Key Freq
100 Hz
FSK Hop Frequency
1 MHz
Phase Deviation
180°
Sweep
Start/Stop Frequency
100 Hz/1.9 kHz
Sweep Time
1 S
Trig Out
Off
Mode
Linear
Direction
Up
Burst
Period
10 ms
Phase
0°
Count
1 Cycle
Trig
Off
Trigger
Source
Internal
30
922869 Rev B