IEI Integration RPC-6106_6108 - Manual (Page 27)

RPC-6106/6108 Rackmount LCD Workstation
o Memory modules (DIMMs)
o CompactFlash
®
disks
Backplane/Motherboard: The backplane or motherboard installed in the
RPC-6106/6108 Rackmount LCD Workstation is separately purchased.
Disk Drives: Disk drives installed into the RPC-6106/6108 Rackmount LCD
Workstation are separately purchased. Disk drive support is CPU card
dependent. Before purchasing a CPU card or disk drives, please check the
CPU card disk drive support.
4.2 Unpacking
4.2.1 Packaging
When shipped, the RPC-6106/6108 Rackmount LCD Workstation is wrapped in a plastic
bag. Two polystyrene ends are placed on either side of the RPC-6106/6108 Rackmount
LCD Workstation. The workstation is then placed into a first (internal) cardboard box. This
box is then sealed and placed into a second (external) cardboard box. The second box is
also sealed. A small box containing accessory items is placed within the internal (first)
box.
4.2.2 Unpacking Procedure
To unpack the RPC-6106/6108 Rackmount LCD Workstation, follow the steps below:
NOTE:
The front side LCD screen has a protective plastic cover stuck to the screen.
Remove the plastic cover only after the RPC-6106/6108 Rackmount LCD
Workstation has been properly installed. This ensures the screen is protected
during the installation process.
Page 17