2 cpu card replacement, 3 pci/isa expansion card replacement, 2 cpu c – IEI Integration RPC-6106_6108 User Manual
Page 51: Eplacement, 3 pci/isa e, Xpansion
RPC-6106/6108 Rackmount LCD Workstation
5.2 CPU Card Replacement
To replace a CPU card, please follow the instructions below.
Step 1:
Turn off and disconnect the workstation from all power sources.
Step 2:
Remove the workstation from the rack in which it is installed.
Step 3:
Open the top cover of the RPC-6106/6108 Rackmount LCD Workstation. (See
Step 4:
Disconnect all internal and external peripheral device connections from the CPU
card.
Step 5:
Remove the retention screw that secures the CPU card to the slot on the front
panel.
Step 6:
Slide the CPU card out of the workstation. Make sure the back edge of the CPU
card slides into the guide rails on the chassis.
Step 7:
Install a new CPU card. (See Section 4.5.6)
Step 8:
Insert the slot retention screw that was removed earlier.
Step 9:
Reinstall the top cover of the workstation. (See Section 4.5.9)
Step 10:
Reinstall the workstation into the rack. Refer to Section 4.6 for complete
mounting instructions.
Step 0:
5.3 PCI/ISA Expansion Card Replacement
To replace a PCI/ISA expansion card, please follow the instructions below.
Step 1:
Turn off and disconnect the workstation from all power sources.
Step 2:
Remove the workstation from the rack in which it is installed.
Step 3:
Open the top cover of the RPC-6106/6108 Rackmount LCD Workstation. (See
Page 41