4 backplane replacement, Ackplane, Eplacement – IEI Integration RPC-6106_6108 User Manual
Page 52
RPC-6106/6108 Rackmount LCD Workstation
Step 4:
Disconnect all internal and external peripheral device connections from the
PCI/ISA expansion card.
Step 5:
Remove the retention screw that secures the CPU card to the slot on the rear
panel.
Step 6:
Slide the expansion card out of the workstation.
Step 7:
Install a new expansion card. (See Section 4.5.7)
Step 8:
Insert the slot retention screw that was removed earlier.
Step 9:
Reinstall the top cover of the workstation. (See Section 4.5.9)
Step 10:
Reinstall the workstation into the rack. Refer to Section 4.6 for complete
mounting instructions.
Step 0:
5.4 Backplane Replacement
To replace a backplane, please follow the instructions below.
Step 1:
Turn off and disconnect the workstation from all power sources.
Step 2:
Remove the workstation from the rack in which it is installed.
Step 3:
Open the top cover of the RPC-6106/6108 Rackmount LCD Workstation. (See
Step 4:
Disconnect and remove all CPU cards (see Section 5.2) and PCI/ISA expansion
cards (see Section 4.5.7).
Step 5:
Remove the retention screws that secure the backplane to the workstation (see
Step 6:
Remove the backplane from the chassis
Step 7:
Install a new backplane into the chassis.
Step 8:
Reinstall and reconnect all CPU cards (see Section 4.5.6) and PCI/ISA
expansion cards (see Section 4.5.7).
Page 42