4 reinstall the drive brackets – IEI Integration RPC-6106_6108 User Manual
Page 36
Advertising
RPC-6106/6108 Rackmount LCD Workstation
4.5.4 Reinstall the Drive Brackets
After the drives have been installed, reinstall the drive brackets into the chassis.
NOTE:
It might be easier to connect the disk drive IDE/SATA connectors to the
ribbon cables and the disk drive power connectors to the PSU before
the drive brackets are reinstalled into the chassis.
Step 1:
Remount the drive brackets in the original position they were removed from.
Step 2:
Make sure all drive bracket retention screw holes are properly aligned with the
corresponding retention screw holes in the workstation.
Step 3:
Reinsert all drive bracket retention screws.
Step 0:
Page 26
Advertising