ATTO Technology 2400C/R/D - Manual (Page 41)

viii
EventLog
Regulates event logging. When enabled, records various
system events to the event log.
Default: enabled
set EventLog [enabled | disabled]
get EventLog
EventLogFilter
Filters data from specific unit subsystems and levels when
event logging is enabled. The specific entries supported are
platform-dependent. For set commands, the final parameter
indicates whether or not events from the specified subsystem
and level are displayed.
Default: all all all
set EventLogFilter [subsystem | all] [event level | all] [all |
none]
get EventLogFilter [subsystem | all ] [level | all]
Exit
Ends the current Ethernet Telnet CLI session; it has no effect if
used during a serial CLI session.
Exit
FCConnMode
Controls/reports the connection the FibreBridge uses when
communication across a FC network, either to an arbitrated loop
(FC-AL) when you select loop, or point-to-point when you
choose ptp. If you choose loop-ptp or ptp-loop, the
FibreBridge tries to use the first parameter first, but uses the
second if it cannot use the first.
Default: loop
set FCConnMode [fp | all] [loop | ptp | loop-ptp | ptp-loop]
Requires a SaveConfiguration Restart command
get FCConnMode [fp | all]
FCDataRate
Specifies the rate the FibreBridge uses, 1 Gb/sec., 2 Gb/sec. 4
Gb/sec. or auto negotiate.
Default: auto
set FCDataRate [fp | all] [1Gb | 2Gb | 4Gb | auto]
Requires a SaveConfiguration Restart command
get FCDataRate [fp | all]
FCHard
Regulates FC hard address assignment. Under soft addressing,
the FibreBridge loop address is assigned during loop
initialization. Use
FCHardAddress if you enable hard
addressing.
Default: disabled
set FCHard [enabled | disabled]
Requires a SaveConfiguration Restart command
get FCHard
FCHardAddress
Specifies the value used as the FC-AL hard address. This value
represents the address that is used if hard addressing is
enabled (refer to
FCHard ). The range of valid FC hard address
values are 0 through 125.
Default fp1=3; fp2=4
set FCHard Address [fp | [address]]
Requires a SaveConfiguration Restart command
get FCHardAddress [fp | all]
FCMultiNode (FB 2400)
Determines the reported identity of Fibre Channel ports. When
enabled, each port reports a separate unique Node Name and
logical units may be mapped to either port. When disabled, each
port reports the same Node Name and each logical unit
mapping is applied to all ports, providing host-side failover and
load balancing capabilities.
Note
Changing this parameter causes all maps to
be deleted. Add new maps using the
AutoMap
or Route commands.
Default: enabled
set FCMultiNode [enabled|disabled]
Requires a SaveConfiguration restart command
get FCMultiNode
FCPortErrors
Displays the number of Fibre Channel errors that have occurred
since the last reboot/power-on or
Reset FCPortErrors
command at the Fibre Channel controller level.
get FCPortErrors [fp | all]
FCPortList
Returns a list of available FC ports and their current status. Valid
status values are Up, Down, Failed, Reserved and
Disabled.
FCPortList
FCSCSIBusyStatus
Specifies the SCSI status value returned when the FibreBridge
is unable to accept a SCSI command because of a temporary
lack of resources. Choices are busy and queue full.
Default: busy
set FCSCSIBusyStatus [busy | qfull]
Requires a SaveConfiguration command
get FCSCSIBusyStatus