ATTO Technology 2400C/R/D - Manual (Page 43)

x
MaxOpTemp (FB 2390, FB 2400)
Regulates/displays the maximum enclosure temperature alarm
of the FibreBridge in degrees Celsius. If the temperature of the
FibreBridge rises above the maximum MaxOpTemp, thermal
control event handling occurs.Valid entries are between 55
degrees and 70 degrees.
Default: 70
set MaxOpTemp [55-70]
Requires a SaveConfiguration Restart command
get MaxOpTemp
MinOpTemp (FB 2390, FB 2400)
Regulates/displays the minimum enclosure temperature alarm
of the FibreBridge in degrees Celsius.Valid entries are between
0 degrees and 15 degrees.
Default: 0
set MinOpTemp [0-15]
Requires a SaveConfiguration Restart command
get MinOpTemp
OpTempWarn (FB 2390, FB 2400)
Regulates/displays the number of degrees in Celsius before a
warning is sent to the user. Valid entries are between 0 degrees
and 15 degrees.
Default: 5
set OpTempWarn [0-15]
Requires a SaveConfiguration Restart command
get OpTempWarn
Password
Specifies password for all non-serial sessions: Telnet, FTP and
ExpressNAV interface. You are prompted for the current
password, to enter the new password, and to confirm the new
password. If local Echo is enabled, password echoes all *
characters. If
VerboseMode has been enabled, CLI requests
that you re-enter the password. When the password is all 0s,
Telnet and FTP do not validate the password and MD5
authentication is disabled.Configure an empty password by
pressing the Enter key when prompted for the new password
and the new password confirmation.Passwords are case
sensitive and can be 1-32 characters long with no spaces.
Default: Password
set Password
Requires a SaveConfiguration command
Performance
Returns the performance data for the FC port you specify. Data
includes the average rate (MB per sec.) and number of I/Os
measured over the previous sampling period where a sampling
period is approximately one second. Successful SCSI Read
(08h, 28h) and Write (0ah, 2Ah) commands are considered
I/Os.Reported performance may be affected by FC port and
SCSI bus availability and saturation, SCSI device speeds and
overall system use.
get Performance <fp>
Ping
Sends an ICMP echo request to the specified host.
Ping [mp1] [xxx.xxx.xxx.xxx] <count <size>>
ReadOnlyPassword
Specifies password for all non-serial sessions: Telnet, FTP and
ExpressNAV interface. ReadOnlyPassword is case sensitive, 0
to 32 characters, and cannot contain spaces. Configure an
empty password by not specifying one.
Default: Password
set ReadOnlyPassword
Requires a SaveConfiguration command
ReadOnlyUsername
Specifies user name for all Telnet, FTP and ExpressNAV user
management console sessions. Username is case
insensitive, 1-32 characters, no spaces.
Default: User
set ReadOnlyUsername
Requires a SaveConfiguration command
get ReadOnlyUsername
Reserve
Prevents other CLI sessions from modifying the FibreBridge.
When the FibreBridge services interface is reserved, set
commands are unavailable but get commands are available. At
least one service interface always has access to the
FibreBridge at all times. This interface always reports
RELEASED status, since it may issue set commands.
Reservation of the FibreBridge is implicit: if the configuration is
changed by any user of CLI sessions, the FibreBridge becomes
RESERVED. Executing a SaveConfiguration command,
RestoreConfiguration or FirmwareRestart forced
releases the FibreBridge so that other devices may modify it.
Reserve
Reset FCPortErrors
Resets all FC error counts for the specified port to zero. Refer
to
FCPortErrors command.
ResetFCPortErrors [fp | all]