ATTO Technology 2400C/R/D - Manual (Page 5)

2.0 Install the FibreBridge ...................................................................................13
Unpack the packing box; verify contents
Install the FibreBridge
Discover the IP address
Internet Explorer setup
Begin initial configuration
3.0 Configure the FibreBridge ............................................................................15
Preliminary steps
Page descriptions
3.1 Map Devices ........................................................................................17
FibreBridge mapping
SCSI device mapping
Mapping devices automatically
Mapping devices manually.
Multiple Node addressing (FB2400 only)
3.2 Monitor, Manage Remotely ................................................................19
SNMP-based monitoring
Email messages provide error notification
4.0 Modify System Values ...................................................................................23
Preliminary steps
Modify passwords
Enhance performance
5.0 Update Firmware ............................................................................................25
6.0 Interface options ............................................................................................27
Using ExpressNAV
Opening an ExpressNAV session
Optimizing ExpressNAV in Internet Explorer
Using the serial port
Using Telnet
Appendix A Cabling ..............................................................................................i
SCSI port connections
Fibre Channel connections
Serial port connections
Ethernet connections
Appendix B CLI provides ASCII-based Interface ...............................................ii
CLI error messages
CLI summary reference
Command explanations
Appendix C Standards and Compliances ...........................................................xv
Appendix D Warranty Information .......................................................................xvii
Manufacturer limited warranty