APC UCCS Temperature Control - Manual (Page 11)

JANUARY 2008 UCCS STANDARDS 15950-11
E. The Contractor shall optimize all control software and tune all control loops to assure
acceptable operating and space conditions and peak energy efficiency. This shall include
changes needed to optimize operation of the systems even if not explicitly described in
Control Strategies.
F. The Contractor shall include the extended warranty for upgrades of ethernet controllers
installed in the building for the warranty year.
G. At the end of the warranty period, the Contractor shall supply updated copies of the latest
versions of all project record documentation as described in Paragraph 1.08, Project Record
Documents. This includes final updated drawings, software documentation, and electronic
media backups that include all changes that have been made to the system during the
warranty period.
H. Coordinate with the UCCS HVAC Shop in
advance before connecting new DDC control system to campus network.
I. Once the building DDC is connected to the network, the Contractor shall notify a
representative of the UCCS HVAC Shop before and after performing any work on the DDC
components, and report any changes made.
J. During the warranty period, University personnel shall make a reasonable effort to
determine if a problem is due to the control system or some other source not the respon-
sibility of the Controls Contractor, before requesting warranty service. However, if the
Controls Contractor is called out and determines that the problem is not due to the controls
system or other building components, the Contractor shall not charge the University for a
service call if it is determined that the source of the problem is not his responsibility.
1.11 QUALITY ASSURANCE
A. This installation shall not be used as a test site for any new products unless explicitly
approved by the Owner's representative in writing. This requirement is not intended to
restrict the Contractor to the use of outdated equipment.
B. All products used in this installation shall be new and currently under manufacture. Spare
parts shall be available for at least ten (10) years after completion of this contract.
C. All DDC components shall be compatible with the rest of the DDC network at the
beginning of the warranty period.
1.12 OWNERSHIP OF PROPRIETARY MATERIAL
A. All project developed hardware and software shall become the property of the Owner.
These include but are not limited to:
1. Project graphic images,
2. Record drawings,