Watlow Series 935B - Manual (Page 18)

18 Watlow Series 935B User’s Manual
The Configuration Menu is the second sub-menu in the Operations Menu. Use it to set Inputs, Ranges, Output Types,
Alarms, Timer, Failure Mode, and Lockouts.
To go to the Configuration Menu:
1. Go first to the Operations Menu by pressing . and , simultaneously for three seconds.
2. Scroll through the Operations Menu with , until you see the [CnFg] prompt.
3. While holding ß to display [``no] , choose [`YES] with . or , .
4. Release ß to see the first [CnFg] prompt, [``In] .
5. To leave the Configuration Menu, press . and , for 3 seconds.
Table 6 - Configuration Menu Overview
Input Type - Choose sensor type. See p. 23 for sensor ranges.
[```J] [```H] [```t] [```n] [```E] [```S] [`rtd] [`r†d]
J t/c K t/c T t/c N t/c E t/c S t/c 1.0° RTD 0.1° RTD
Celsius/Fahrenheit - Choose displayed unit of measure.
[``°F] [``°C]
°F °C
Input Range Low - Select lowest displayable set point. Ranges, p. 23.
[``In] [``rh]
Select a value (lowest displayable set point) between Input Type Range Low and Input Range High.
Input Range High - Select highest displayable set point. Ranges, p. 23.
[``Rl [``In]]
Select a value (highest displayable set point) between Input Type Range High and Input Range Low.
Output 1 Function - Choose Output 1 type; see Valid Outputs Table, p. 23
[hEAt] [COOL] [ALM] [nonE]]
Heat Cool Alarm None
Output 2 Function - Choose Output 2 type (dependent on Output 1 choice).
hEAt] [COOL] [ALM] [thM] [tMS] [nonE]
Heat Cool Alarm Timer Timer None
Hr./Min. Min./Sec
Remote Timer Start - Choose remote timer start operation.
[`off] [`fpl] [tmr]
Off Front Panel Countdown
Lock
Timer
Display Default - Choose the primary (last 2 characters) and secondary (first 2 characters) default displays. Press ß to toggle to the
secondary display for 15 seconds.
[``Ac] [AcSP] [Acti] [tiAc] [tiSP]
No secondary Actual temp. Actual temp. Time remaining Time remaining
Actual temp. Set pnt temp. Time remaining Actual temp. Set point temperature
Alarm Type - Choose alarm type with output action.
[Prnc] [Prno] [dEnc] [dEno]
Process Process Deviation Deviation
normally normally normally normally
closed open closed open
[``In]
[`C_F]
[``rL]
[``rh]
[`Ot1]
[`Ot2]
[dISP]
[ALty]
Learn the Configuration Menu
[`rts]