Boltek EFM-100 v.2 - Manual (Page 34)

C H A P T E R 3 – C O N F I G U R I N G T H E S O F T W A R E
28
EFM Options: Data Sharing
Figure 24: EFM Options – Data Sharing
Field Mill Selector
Select the field mill for which you would like to configure data sharing.
Enable Sharing Checkbox
Check the Enable Sharing checkbox if you wish to share your field mill data with others. If enabled
your EFM-100 software will list on the Listen Port for incoming connections. Once a connection
has been made the software will begin transmitting field mill data to the remote computer. There is
no limit to the number of concurrent connections.
Listen Port
This is the port on which your computer will listen for incoming connections. Each field mill being
shared on one computer must have a unique port number.