LT Security LTD6299 - Manual (Page 36)

- 35 -
„ Alarm Out – to define which Alarm Output will be triggered when video loss of this
camera is detected. Press +/- buttons to select none (N/A) or one of the Alarm Outputs
(1-4).
„ Buzzer – to activate the internal Buzzer or not when video loss of this camera is detected.
Press ENTER to check/uncheck this item. The default setting is “ˇ” - checked.
„ Log – to log to event logs or not. Press ENTER to check/uncheck this item. The
default setting is “ˇ” - checked.
„ Screen Message – to display the event message on the screen or not. Press ENTER
to
check/uncheck this item. The default setting is “ˇ” - checked.
„ E-mail – to send the event e-mail to remote station or not. The e-mail will be sent to the
predefined receivers at the moment when the event is triggered. Press ENTER to
check/uncheck this item. The default setting is “–” - unchecked.
6.2.2 Motion Setup
In Camera Setup, press ENTER to call up Motion Setup as shown when the highlighted
option is Motion Settings.. of the camera to setup. The Motion setup allows the
administrator to define how the system responds to the detected motion for the camera.
The general operations are as below:
„ ▲▼◄►
Press these buttons to select the items.
„ Numeric (ENTER)
Press these buttons to select the camera.
„ COPY ( )
Press this button to copy the Motion settings, including Detection settings, of the focus
camera to all the following cameras. (EX. focus camera is 5, its Motion settings will be
copied to those of cameras 6-16.)