LT Security LTD6299 - Manual (Page 37)

- 36 -
„ ESC
Press this button to escape from this screen, and return to Camera Setup display. If the
Save dialog is shown, press ENTER to exit and save, ESC to exit without saving.
Following is a brief description for each item and its specific operations:
„ Duration – response duration to define at most how long (in seconds) the Alarm Out
relay and the Buzzer will keep being triggered after motion is detected for this camera.
However, the Alarm Out relay and the Buzzer will be reset immediately once the camera
returns to normal. Press +/- buttons to adjust the value (3 seconds - 60 minutes, discrete,
‘-‘ for ‘Forever’).
„ Goto Preset – to define the preset position to go to if motion is detected and this camera
is a PTZ camera. For more details about preset locations, please refer to Chapter 7 PTZ
Control .
„ Pre-record – to define how long before motion is detected this camera shall be
intensively recorded at Pre-record IPS. Press +/- buttons to adjust the value (0-60
seconds, discrete). Please note that the actual pre-record time may be shorter than the
value set if the total size of the pre-record pictures exceeds the pre-record buffer size of
the system.
„ Post-record – to define how long after motion is detected this camera shall be intensively
recorded at Event Record IPS. Press +/- buttons to adjust the value (0 second - 60
minutes, discrete).
„ Alarm Out – to define which Alarm Output will be triggered when motion of this camera
is detected. Press +/- buttons to select none (N/A) or one of the Alarm Outputs (1-4).
„ Buzzer – to activate the internal Buzzer or not when motion of this camera is detected.
Press ENTER to check/uncheck this item. The default setting is “ˇ” - checked.
„ Log – to log to event logs or not. Press ENTER to check/uncheck this item. The
default setting is “ˇ” - checked.
„ Screen Message – to display the event message on the screen or not. Press ENTER to
check/uncheck this item. The default setting is “ˇ” - checked.
„ E-mail – to send the event e-mail to remote station or not. The e-mail will be sent to the
predefined receivers when the event is triggered. Press ENTER to check/uncheck this
item. The default setting is “–” - unchecked.
„ Detection Settings.. – used to setup the motion detection settings, including detection
area and sensitivity, when motion is detected for this camera. Press ENTER in Settings..
to call up Motion Detection Setup (as shown) for this camera. In Motion Detection
Setup, the video area is divided into many small grids, and the area with transparent
grids is the area which will be detected for motion, while gray grids not detected for
motion. Besides, there is a (green) Mask window.