Gps error messages – Seed Hawk Raven 2011 User Manual

Page 205

Advertising
background image

11

Manual No. 016-3001-003

195

Troubleshooting the Viper Pro System

GPS Error Messages

No Rx file chosen
for this product

• VRC was selected for the

product during the
product setup, but no Rx
map was loaded

• Un-select the VRC selection or load an Rx map for the

product.

No Rx rate field
chosen for product

• VRC was selected and

an Rx map was loaded,
but a selection was not
made in the Rate field

• Select the appropriate item from the Rate field.

When VRC is
checked, a
Prescription File and
Rate Field must be
supplied

• VRC was selected during

the product setup, but a
prescription map and rate
field have not been
selected

• Press Browse to select the appropriate prescription

file. Select the appropriate rate item in the Rate field.

Color templates are
available only when
VRC is selected

• You selected a color

template without
selecting VRC

• You can only select a color template when you have

selected VRC and have loaded a prescription map.

Issue

Possible Cause

Solution

No GPS Coverage
warning

• You must have GPS

coverage to start a non-
VRC (Variable Rate
Control) job

• Make sure that the GPS data is being received by the

Viper system.

Warning: You do not
have optimum GPS
coverage. Some
features may be
disabled.

• GPS reception does not

have differential
correction. Therefore,
some features, such as
guidance, will not be
available when starting a
job in this condition

• Enable the differential correction function in the GPS

receiver. Contact the receiver manufacturer for
additional information.

No Differential

• Differential GPS has not

been detected by Viper

• Check the GPS receiver to make sure that it has the

differential correction function. Contact the
manufacturer for additional information.

No GPS

• Viper does not detect a

GPS signal

• Make sure that the GPS receiver is turned on and

receiving a signal.

• Make sure that the port setting for Viper and the GPS

receiver match.

• Make sure that the required NMEA messages are

turned on in the GPS receiver.

Issue

Possible Cause

Solution

Advertising