Seed Hawk Raven 2011 - Manual (Page 55)

3
Manual No. 016-3001-003 45
CAN (Controller Area Network) Setup
Tank Volume
Enter the estimated volume of product in the tank. This value must be reset each time the tank is refilled. The
Low Tank Alarm feature is based upon the value entered in this field.
Review the Low Tank section on page 33 for information about setting the Low Tank Alarm. See the Tally
Registers section on page 53 for information on resetting the tank volumes to a preset value.
Rate Cal
Enter the target rate for the product controlled via the selected product node.
Rate Bump (+/-)
The rate bump setting is the value which the target rate is increased or decreased by toggling the INC/DEC
switch on the Seed Hawk switch box.
See the Application Rates section on page 69 for more information about the Application Rates Area on the
main screen and using the rate bump feature during a field application.
Meter Cal/Density
Depending upon the selected application type, either the meter cal or density setting will be displayed in Data
Box 2. See the Application Area section on page 51 for information about setting the type of product
application.
For liquid product application, the meter cal must be entered to calibrate the Viper Pro to the specific flow
meter used to measure product application. The meter cal value is typically found on the flow meter.
For granular products, enter the product density or weight of 1 cubic foot of product in the density setting. The
density of the product must be entered to calibrate the Viper Pro to the weight of product being applied.
Spreader
For granular applications, the specific spreader constant for your gate vehicle’s setup must be entered in this
field.
Note:
Enter a zero in this field when applying liquid products.