Seed Hawk Raven 2011 - Manual (Page 24)

Chapter 2
14 Seed Hawk™ Viper Pro™ Installation & Operation Manual
2. The Program Selection Menu will display if the Viper Pro was powered off at this screen the last time the
console was on.
Note:
To skip the Program Selection Menu next time the Viper Pro is powered up, shutdown the console
from the Viper Pro application. Within the Viper Pro application, touch the Menu button in the lower
right corner of the screen and select Exit, Shutdown Viper.
Select the:
• Brightness Control option to adjust the screen brightness.
• Front Panel option to configure Raven DGPS Receivers directly with the Viper Pro using the
Front Panel Program. See Appendix G, Using the Front Panel Program with the Viper Pro
System, for detailed instructions on setting up and using the Front Panel Program.
• XP Desktop option to view the Windows desktop on the Viper Pro console.
• Install Viper Pro option to install the Viper Pro application. This option is only displayed if a
thumb drive containing the Viper Pro startup directory is inserted into the Viper Pro console.
• Update CAN Nodes option to update CAN nodes using the Viper Pro console. This option only
displays when the CAN Update program is detected on a connected USB flash drive. See
Appendix F, Updating CAN Nodes on the Viper Pro Console, for more information.
• Calibrate Screen button at the bottom of the screen to begin the touch screen calibration
wizard.
3. Select the Seed Hawk option to launch the Viper Pro precision application management system.