Fire-Lite PRN-6 Reference-Manual - Manual (Page 10)

Messages in the
LC display If the printer detects an internal fault or user error or if it expects you to do
something, a message will appear in the LC display. Below you will find a
list of messages with brief descriptions of each message. The messages
are described in more detail in the section
Troubleshooting in chapter 3
Troubleshooting, care and maintenance.
Message Meaning
Eject error The printer cannot eject paper/advance it to park position.
Hardware Alarm Internal hardware error/print head blocked.
Head hot The printer reports that the print head is hot and that print
speed will be reduced.
Initializing This message appears during the printer’s initializing
phase.
Load error The printer cannot draw in the loaded paper.
Loading default Indicates that the printer is being initialised and is
carrying out the internal self-test immediately after
turning on the printer.
Load paper from
Single
Tractor1
Tractor2
ASFauto
The printer has detected paper end during operation or
the printer was switched on with no paper loaded.
The user is requested to insert paper into the paper input
selected.
Parity error A parity error during data transmission is indicated.
Press any key The user is requested to press any key.
Tear Paper off The user is requested to tear off paper which has been
advanced to the quick tear edge.
Turn paperlever The user is requested to turn the paper type selection
lever.
1
4
The control panel
1 - 3
BACK QUIT
?