Fire-Lite PRN-6 Reference-Manual - Manual (Page 17)

Now the following message appears in the LC display:
Now press the key
<
or
>
repeatedly until “Load Menu=3” appears. Then
select menu no. 3 as the current setting using the Set key. After you have
completed this change the printer initialises itself and a corresponding
message is displayed in the LC display.
The currently valid setting ist marked by a “ * ”
Menu handling
You move from menu item to menu item using the four function and selection
keys underneath the LC display. Every function and every parameter
displayed on the LC display is effected/selected by the key directly under-
neath. For this reason the function and selection keys are referred to in this
manual by their current assignment. Generally two parameter groups
occupy one level (in the following picture the parameter groups LPI and
Skip occupy one level).
If you do not wish to change one of the two parameters you can either
press the Next key (to access the two following parameter groups in the
menu), or you can press the Back key (to access the two previous
parameter groups in the menu). If you want to change a setting, (e.g. the
line density), then press the LPI key (LPI = lines per inch) to access the
actual parameter level. The currently valid setting is marked by a “
* ” (in
the example below the current setting is 6 lpi). With the “<” and “>” keys
you can view the other parameters available for this setting.
Setup
Load Menu=1 *
Set < > Exit
Online
Programming via the control panel
1 - 10
BACK QUIT
?