Fire-Lite PRN-6 Reference-Manual - Manual (Page 25)

Menu description table
1-18
ASF-auto
FormAdj 0/72 – 72/72; 12/72 *
Values for automatic sheet feeder can be set.
AutoTear ViewTear = Off *
View =1s
3s
6s
Tear = 1s
3s
6s
Tear at TOF
The Auto-Tear function, the Auto-View function or the
Tear
at TOF function can be selected optionally. With Auto-
View switched on, the text which was printed last can be
viewed. As soon as the printer receives data, the paper is
transported back to the “normal” print position. After the
print process has been completed, the printer waits the
preset interval and then transports the paper back to the
Auto-View position.
With Auto-Tear switched on the paper starting position is
in the quick tear position, i.e. the paper’s quick tear perfo-
ration is positioned on the printer’s quick tear edge. As
soon as the printer receives data, the paper is trans-
ported back to the normal print position. After the print
process has been completed, the printer waits the preset
interval and then transports the paper back to the quick
tear position. If the quick tear edge is not level with the
paper perforation, this can be corrected (see the opera-
tor’s manual, Moving paper to the tear position).
If Tear at TOF is selected instead of the AutoTear or Auto-
View function, the printer feeds the fanfold paper up to the
tear edge when 1. no print data are queuing up and 2.
when the printer is in TOF position.
Width 8 inch
13,2 inch
13,6 inch *
Sets the line length in inches. This parameter group is
only displayed in the menu of the wide printer.
F-Eject Off *
ASF
Single
All Changes the paper outfeed of cut sheets.
Off: paper outfeed to the rear
ASF: paper outfeed to the manual sheet feeder
Single: paper outfeed to the front
All: Both to the manual sheet feeder
Formlen
Trac.1
Form length adjustment.
You can select from two different form lengths.
This form length is applicable to paper in tractor 1, in the
manual cut sheet feeder and in the automatic sheet
feeder (ASF).
Parameter group Parameter Description
BACK QUIT
?