Fire-Lite PRN-6 Reference-Manual - Manual (Page 40)

✔ ✔ <ESC><SP><n> set character spacing (<n> = 0 - 127)
✔ ✔ <ESC>= set bit 8 = 0
✔ ✔ <ESC>=<C1><C2>... downloading fonts/characters
✔ ✔ <ESC>> set bit 8 = 0
✔ ✔ <ESC>?<s><n> reassign graphics mode
<s> = K, L, Y or Z
<n> = 0 - 4, 6, 32, 33, 38 - 40
✔ ✔ <ESC>@ printer initialization
✔ * * * * * <ESC>[?53h column 8+9 of the character table are printable characters
✔ * * * * * <ESC>[?53 l column 8+9 of the character table are printable characters
or ignored (dependent of emulation)
✔ ✔ <ESC>[@<n1><n2>... set double height
✔ <ESC>[\<n1><n2>... changes vertical basic graduations
✔ <ESC>[F sheet feeder
✔ <ESC>[g<n1><n2><0> graphics 60 dpi
✔ <ESC>[g<n1><n2><1> graphics 120 dpi
✔ <ESC>[g<n1><n2><11> graphics 180 dpi
✔ <ESC>[g<n1><n2><12> graphics 360 dpi
✔ <ESC>[g<n1><n2><2> graphics 120 dpi
✔ <ESC>[g<n1><n2><3> graphics 240 dpi
✔ <ESC>[g<n1><n2><8> graphics 60 dpi
✔ <ESC>[g<n1><n2><9> graphics 120 dpi
Formula: n = length of graphics data bytes
<n2> = INT (n/256)
<n1> = n MOD 256
✔ <ESC>[T<n1><n2> select character set
✔ ✔ <ESC>\<n1><n2> set relative horizontal step
Formula: n = relative print position
<n2> = INT (n/256)
<n1> = n MOD 256
✔ ✔ <ESC>\<n1><n2> transparent mode for following characters
Formula: n = number of characters to be printed
<n2> = INT (n/256)
<n1> = n MOD 256
✔ ✔ <ESC>^ transparent mode for the following character
✔ <ESC>^ select 9 pin graphics mode
✔ ✔ <ESC>_<1> overscore mode ON
IBM IBM Epson Epson IBM-
MTPL Propr. Propr. FX850 LQ850+ AGM Code Function
XL XL24 FX1050 LQ1050+
2
4
List of available control codes
2 - 11
BACK QUIT
?