Fire-Lite PRN-6 Reference-Manual - Manual (Page 21)

Menu description table
1-14
CPI 5 / 6 / 7,5 / 8,6 / 10 * /
12 / 15 / 17,1 / 20 CPI Selects the character density (cpi = characters per inch).
LPI 2 / 3 / 4 / 6 * / 8 / 12 LPI Selects the line density (lpi = lines per inch).
Skip 0 * / 0,5 / ... / 3,5 inch Selects one of seven defined values for skip over the
paper fold.
ESCChar ESC *
ESC+$$ The type of escape character which leads escape
sequences can be selected. Escape character only or
escape character plus two $$ characters. (You will find a
description in chapter 2.)
Emulate
MTPL
Epson LQ850+/
LQ1050+ *
IBM Propr. XL24
IBMProXL24+AGM
IBM Propr. XL *
MTPL
Epson FX 850+/
FX1050+
Selection of the emulation mode. The MTPL emulation is
also available in the other emulations.
The sequences of the IBM AGM mode are basically the
same as those of the IBM Proprinter XL24. The graphics
commands are similar to those of the Epson mode.
Note:
Epson LQ850+
➨ narrow printer
Epson LQ1050+ ➨ wide printer
Bidir On *
Off Switch on/off bidirectional printing.
I/O
Buffer
Serial
Baud
0 / 1,7 / 10 / 40 / 64
kB
0 / 1,7 / 19 / 40 / 64 kB
19200
9600 *
4800
2400
1200
600
300
The standard version is equipped with a parallel interface
only..
Selection of the size of the interface buffer.
Values 0 are not displayed if the serial interface is
installed.
This parameter is displayed only if the serial interface
module is installed.
Selection of Baud rate for data transmission (Baud = bits
per second).
Parameter group Parameter Description
BACK QUIT
?