Fire-Lite PRN-6 Reference-Manual - Manual (Page 58)

Setting the Formlen
function The Formlen function allows you to set the basic form length to meet your
requirements. 12 inches are usual in Europe, as opposed to 11 inches in
the USA.
Select the Formlen menu.
Setting options: 12 inches or 11 inches
Default setting: 12 inches in 230 V printers
Default setting: 11 inches in 120 V printers
The value defined here is set in all three menus and for all paper paths if
you load the default configuration by holding all four soft keys while
switching on the printer (see chapter 1
Key functions when turning on the
printer).
Confirm your setting by pressing the key Set.
Online
Formlen
Back Next
Setup
Setup
Formlen=12" *
Set < > Exit
Online
Interface test (Hex-Dump)
3 - 8
BACK QUIT
?