Ac a b – SUOMY Vandal User Manual

Page 14

Advertising
background image

FRONT AIR INTAKE - OPERATION - see figure 4

The airflow entering the front of the helmet (chin guard) can be adjusted by means of lever (A) located in the centre of
the air intake:

- position (B):

lever down - air intake fully closed

- position (C):

lever up - air intake fully open.

The lever clicks into place in both the fully open and fully closed positions.

PRISE D’AIR AVANT - FONCTIONNEMENT - voir figure 4

Le flux d’air qui pénètre dans la partie avant du casque (mentonnière) peut être réglé en agissant sur le levier (A) situé
sur la partie centrale de la prise d’air:

- position (B):

levier vers le bas - prise d’air complètement fermée

- position (C):

levier vers le haut - prise d’air complètement ouverte.

Deux positions d’arrêt, reconnaissables à un léger déclic qui se fait entendre durant la manipulation, sont prévues pour
les positions complètement ouverte et complètement fermée.

PRESA D’ARIA FRONTALE - FUNZIONAMENTO - vedi figura 4

Il flusso di aria in ingresso nella parte frontale del casco (mentoniera) può essere regolato agendo sulla levetta (A) posta
nella parte centrale della presa d’aria:

- posizione (B):

levetta verso il basso - presa d’aria completamente chiusa

- posizione (C):

levetta verso l’alto - presa d’aria completamente aperta.

Sono previste due posizioni di fermo, avvertibili da un leggero scatto durante l’azionamento, nelle condizioni completamente
aperto e completamente chiuso.

FRONTSEITIGE LÜFTUNGSÖFFNUNG - FUNKTIONSWEISE - siehe Abbildung 4

Die im frontseitigen Helmbereich (Kinnteil) einströmende Luft kann anhand des Hebels (A) im mittleren Teil der Lüftungsöffnung
reguliert werden:

- Stellung (B):

Hebel nach unten - Lüftungsöffnung vollständig geschlossen

- Stellung (C):

Hebel nach oben - Lüftungsöffnung vollständig offen.

Vorgesehen sind zwei Feststellpositionen - vollständig offen und vollständig geschlossen. Beim Erreichen der Feststellposition
ist ein kleines Klicken zu vernehmen.

TOMA DE AIRE FRONTAL - FUNCIONAMIENTO - véase figura 4

El flujo de aire en la entrada de la parte frontal del casco (mentonera) puede regularse actuando sobre la palanca (A)
situada en la parte central de la toma de aire:

- posición (B):

palanca hacia abajo - toma de aire completamente cerrada

- posición (C):

palanca hacia arriba - toma de aire completamente abierta.

Existen dos posiciones de tope, perceptibles por un suave clic durante el accionamiento, en las posiciones completamente
abierta y completamente cerrada.

V A N D A L

V A N D A L

1 4

4

E

INSTRUCCIONES DE USO

D

GEBRAUCHSANLEITUNGEN

I

ISTRUZIONI D’USO

F

MODE D’EMPLOI

G

USER’S INSTRUCTIONS

A

C

A

B

Advertising