References, Units, Peak mode – Crystal FastCalXP Calibration Software User Manual
Page 51
Frequently Asked Questions
49
FastCalXP Operation Manual
REFERENCES
Why doesn’t the Calibration Wizard detect my reference?
Be sure that the serial cable connectors are properly seated and that the reference has been turned on. If the software still does not detect the reference, check the number of the serial port on the computer.
Choose
Options
from the Tools menu.
On the
Confi g Settings tab
,
verify that the
XP2/Model 30 serial por
t
is the same as that to which the serial cable is connected.
I am using a Model 30 for a reference. Can I still use Peak Mode?
Yes. The peaks are detected within the FastCalXP software so you can use a gauge that does not have its own peak feature.
UNITS
Why don’t I see anything in the Units portion of the Database Manager?
Only units added by an operator can be edited with the Database Manager so only these units are listed. Refer to the list of FastCalXP Pressure Units in Appendix A to fi nd conversions to PSI.
PEAK MODE
I have selected Peak Mode. Why doesn’t my computer beep when I stop at a target?
Auto Peak detection is not turned on. Choose
Options
from the Tools menu, click on the Calibration Settings tab and click to check the Auto Peak Detection box.