PATLITE FV-127JP User Manual
Page 27
- 27 -
【
Procedure for transferring voice message data】
1. Turn the power off.
2. Set DIP switch 5 to “ON” and DIP switch 6 to 'OFF' to set the writing mode.
3. Insert the SD card with the saved data to write into the SD card slot.
For the procedure on how to make data, refer to the PATLITE Playlist Editor Help (included on CD)
for the method to create message data.
4. Upon reapplying the power, the data transfer will commence.
•
While data is being transferred, the red LED indicator will turn on.
→If an error occurs, the red LED indicator will blink,
☞
Refer to pg. 38 [9. Error Table] for troubleshooting guidlines.
•
Data writing should take a maximum of 180 seconds to complete.
•
If the power is turned off during the data transfer, the data will not be completed and
possible data corruption may occur. If this happens, repeat from step three to rewrite the
data.
5. When data transfer is completed, the green LED indicater will turn on.
Turn the power off and remove the SD card.
6. Set DIP switch 5 to the 'OFF' position to set for the normal mode.
Upon reapplying the power, the transferred data will be ready to play back.
7. Verify the data was correctly transferred by playing back the voice messages.
•
If the voice message does not playback properly:
Format the SD card for FAT16 before generating the data.
( ☞ Refer to pg. 31 [ 【SD Card Formatting】 ])
(c) Export Mode
The voice messages located in the internal memory can be read into the SD card.
With the read data, the collection reorganization can be performed.
•
With the read data, the voice message can be reread for this product.
•
Even with the data read, the internal data can remain intact.
•
With the read data mode, messages cannot be played back.
O F F
1
2
3
4
5
6
7
8
(b) Write Mode
Before exporting data from the internal memory to the SD card, ensure no volatile memory is
stored on the SD card. Data on the SD card will be overwritten.
Important