PATLITE FV-127JP - Manual (Page 6)

- 6 -
5. Volume (Speaker, AUX)
Volume adjustment for the Speaker and AUX output is possible.
( ☞ Refer to pg. 20 [6-1 Volume Adjustment])
6. Terminal Bus
Wiring terminal for individual Inputs and Outputs. ( ☞ Refer to pg. 10 [5. Wiring])
7. DIP Switches (Sets Functions)
Sets functions for playback mode, SD card operation, etc.
( ☞ Refer to pg. 22 [7. Mode Switch Settings])
8. SD Card Slot
Used for voice message rewriting, voice message exporting and SD card permanent installation.
( ☞ Refer to pg. 31 [7-3. SD Card Operation])
[SD Card Slot Insertion]
When inserting, please push the SD Card in until a click is heard, and insert the SD Card as indicated in the
diagram below.
To remove the SD Card, push in until a click is heard and release.
9. FG Hole (Frame Ground Hole)
In some cases, the earth grounding reduces noise.
The Terminal bus is connected to the FG Hole.
10. Noise Filter Pin (A , B)
Depending on the pin setting, incoming noise can be reduced.
Both pins are connected upon shipment, but by removing any of them may increase noise susceptibility.
Therefore, set the pins in accordance to the operating environment.
( ☞ Refer to pg. 13 [ ② FG Terminal Wiring/Noise Reduction Pin])
SD Card
SD
Card
Slot
When you insert an SD card into the SD card slot, be careful of the direction. Also, don't push in SD card by
force. Possible damage of the product and SD card may occur.
%CWVKQP