4. input hold time, 5. speaker output – PATLITE FV-127JP User Manual
Page 29
- 29 -
【
Exclusive SD Card Mode Setup Procedure】
1. Disconnect the power source.
2. Set DIP switch 5 and DIP switch 6 in the “ON” position for the Permanent SD Card Mode.
3. Insert the SD card with the data stored into the SD card slot.
For the procedure on how to make data, refer to the PATLITE Playlist Editor Help (included on
CD) for the method to create message data.
4. Turn the power back on to reboot the product, and the stored SD data will playback.
→If the red LED starts to fl ash, an error occurred.
☞
Refer to pg. 38 [9. Error Table] if an error occurs.
•
In case the voice message does not playback properly:
Reformat the SD card for FAT16 and recreate the data.
( ☞ Refer to pg. 31 [ 【SD Card Formatting】 ])
7-4. Input Hold Time
The input hold time for the input terminals can be set for either 10ms or 50ms.
When shorting the individual channel terminal wires to the common (COM), ensure the input is held
for at least the duration set for the input hold time.
The factory setting is for 10ms, but in case the environment contains a lot of noise, by setting the
Input Hold Time to 50ms, it might make it more diffi cult to receive the incoming noise.
7-5. Speaker Output
The speaker output can be set for either a 4W or 2W output.
O F F
1
2
3
4
5
6
7
8
Factory Settings
O F F
1
2
3
4
5
6
7
8
50ms
10ms
O F F
1
2
3
4
5
6
7
8
Factory Settings
O F F
1
2
3
4
5
6
7
8
2 Watt
4 Watt
O F F
1
2
3
4
5
6
7
8
(d) Permanent SD Card