PATLITE FV-127JP - Manual (Page 28)

- 28 -
【 Voice Message Exporting Procedure】
1. Disconnect the power source.
2. Set DIP switch 5 in the “OFF” position and set DIP switch 6 in the “ON” position for the
exporting mode.
3. Insert the SD card into the SD card slot.
4. Turn the power back on to reboot the product, and the data export will start.
While data is being exported, the red LED will turn on.
→If the red LED starts to fl ash, an error occurred.
☞
Refer to pg. 38 [9. Error Table] for troubleshooting if this occurs.
• Data export should take a maximum of 180 seconds
• Do not disconnect power during data transfer or the data may become corrupted.
If this happens, disconnect the power and perform the export again.
5. When exporting has been completed, the red LED will fl ash.
Turn off the power, remove the SD card and reset the DIP switches to a playback mode.
6. Verify the data transfer to the SD card has been successful.
(d) Permanent SD Card Mode
Without the use of the internal memory, the voice message data is taken from the SD card for playback.
A maximum 240 minutes of playback is available with the optional SD card (SDV-128P).
( ☞ Refer to pg. 38 [ ① SD Card (MP3 Voice Message Upload)])
• Replay messages with the SD card inserted.
• The internal data remains intact.
• Only the data from the SD card can replay. The SD card in combination with the internal data won’t play back
messages.
• If the SD card is not inserted, no voice message will play back.
O F F
1 2 3 4 5 6 7 8
(c) Export Mode