PATLITE WDR-LE - Manual (Page 21)

19
Wireless Data Aquisition System Comprehensive User's Manual
6.4 Receiver Setup (WDR-LE）
:DUQLQJ
Prohibited
Please do not allow liquid to penetrate the inside of the receiver (WDR-L/U), or to contact
with any metals.
May result in fi re or electric shock.
&DXWLRQ
Enforced
After breaking-out the wiring hole, be sure no burs remain.
Friction from wire rubbing against burs may result in wire disconnection.
Be careful while breaking-out the wiring hole.
Possible injury may occur.
■ WDR-LE
Refer to the following drawings for mounting and wiring.
1
Remove Top Cover.
2
Break-out the Wire Hole.
Wire Hole (Backside)
If using the backside, remove the break-out (indicated
in red) with nippers.
Wire Hole (Bottom)
In case the hole is too small for wiring, use nippers to
remove the break-out (indicated in red) for a larger
hole.
3
When mounting the receiver, tap a hole for an
M4 sized screw or a 4mm diameter.
Note
● Screws are not included.
The thickness of the receiver casing is 3mm. Select
the proper screw length in consideration of the
thickness.
Cover
Wire Hole
（Wall）
Wire Hole
（Bottom）
Screws
83.5mm