PATLITE WDR-LE - Manual (Page 67)

65
Wireless Data Aquisition System Comprehensive User's Manual
■ Wireless Settings
Use the "Transmitter Settings" tab and "Receiver Settings" tab in the application software for each unit.
No. Setting Index Description
❶ PanID １∼４ ① For Reciever side
・Wireless module setting for PanID candidate.
・PanID １is prioritized and the next available PanID is searched when a collision
occurs.
・Valid range is from 0x0000 to 0x03FF.
② For Transmitter side
・When a wireless module is added to the network for a PanID candidate.
❷ Frequency Channel
（ChannelList）
① For Reciever side
・The frequency band of the wireless module in use.
・The range is from 2405MHz (Ch11) to 2480MHz （Ch26） in 5MHz steps.
・The band is activated when the box is check marked.
・Multiple channels can be set from Ch 11 to Ch 26.
＜ Ex. ＞ All Channels 0x07FFFF800
Only Ch11 (2405MHz） 0x00000800
② For Transmitter side
・The frequency band of the wireless module in use.
・The range is from 2405MHz (Ch11) to 2480MHz （Ch26） in 5MHz steps.
・The band is activated when the box is check marked.
・Multiple channels can be set from Ch 11 to Ch 26.
・Appoint specifi c band ranges for the network to retrieve for connections.
❸ Module Setting（NwkStart）
（Setting only for Receiver）
・Upon power-up, the module can be set to automatic boot-up or manual
connection to the network.
・Please set wireless module for automatic boot-up.
・Manual connection is reserved only for maintenance purposes.
❹ Output Strength
（PowerLevel）
・RF output strength setting for wireless transmission.
・Setting range is from 0x00 （Min.） to 0x0F （Max.).
・Adjust in accordance to the surrounding environment.
❺ Status Condition Setting
（Only for Transmitter）
Settings for network status conditions between receiver and transmitters.
A status confi rmation notifi cation command is sent to the reciever at a defi nite
period of time.
・Heartbeat ：Measured in seconds, range from 0x00 to 0xFF.
Setting of 0x00 invalidates Status Condition Setting.
Please
● If the Heartbeat is set for 0x00, the Watch also
has to be set to 0x00.
・Watch ：Status confi rmation notice time-out when receiver is
checking transmitter withdrawal.
Set in the range of 0x00 to 0xFF
When a time-out is recognized, a notifi cation
command is sent via the LAN or USB connection.
Please
● For the Heartbeat settings, use the following formula to stay within the tolerable
settings.
Watch（sec） ＞ Heartbeat（sec）×５
❻ Group ID
（Only for Receiver）
・ID setting to restrict the transmitters participation in the network.
・With the same Pan ID, the Group ID can restrict transmitter participation in
specifi ed grouped networks.
・When using this setting, it is recommended to use the Receiver MAC Address.