PATLITE WDR-LE - Manual (Page 79)

77
Wireless Data Aquisition System Comprehensive User's Manual
■ Return to Factory Settings（WDR-L and WDT）
In case the IP Address set up for the WDR-L, or the wireless settings for the WDT is unknown, the settings
can be cleared and returned to factory settings.
＜ For WDR-L ＞
Return the IP Address to "192.168.0.1".
1
Turn the power off .
2
Turn "DIP Switch1" to the "ON" position.
3
Turn the power back on.
➡ The power LED （Green) should turn on.
4
The Output LED (Red) should turn on after about fi ve (5) to ten (10) seconds.
5
After the Output LED (Red) has turned on, turn the power off , again.
6
Return "DIP Switch1" back to the "OFF" position.
＜ For WDT ＞
The setup value to the wireless module will return to factory settings.
1
Turn the power off .
2
Turn "DIP Switch1" to the "ON" position.
3
Turn the power back on.
4
Wait for about one (1) second for the Status LED to fl icker between green and red.
5
After the Status LED has stopped fl ickering between green and red, turn the power off .
6
Return "DIP Switch1" back to the "OFF" position.
Note
● The following is the wireless setting default
No. Name Function
❶ PanID (0x0210) PanID1：１ PanID2：２ PanID3：３ PanID4：４
❷ Frequency Channel (0x0211) ChanList：0x07FFF800
❸ Status Confi rmation Setting (0x0237) Heartbeat：0x00 （No notice sent） Watch：0x00
❹ Group ID (0x0247) GrpID：0xFFFFFFFFFFFFFFFF