Canon imagePROGRAF iPF750 MFP M40 - Manual (Page 401)

Setting Details
30sec. / 1min. / 3min. / 5min. /
10min. / 30min. / 60min. The sheet is ejected when the specified time after printing has elapsed.
Between Scans
This sets the wait time between line scans during printing.
Setting Details
Printer Default The settings of the printer operating panel are applied.
None The printing continues to the next line immediately after the last line.
1sec. / 3sec. / 5sec. / 7sec. / 9sec. The printing continues to the next line after the set time.
*For the media type that has problems, such as ink smears on the page or colors that
seem uneven during borderless printing etc., increase the value for this setting.
• Roll Paper Margin for Safety
Near End Margin
This sets the length of the near end margin of the roll paper.
Setting Details
Printer Default The settings of the printer operating panel are applied.
3mm Print at a standard size.
*Select for Media Type that has no problem when printing with a standard size mar-
gin.
20mm This setting sets the margin about 17 mm (in the feed direction) longer than the
standard margin for the media size.
*This is for Media Type that has a strong tendency to curl, causing the printhead to
scratch the surface.
Important
• If you make the margin (white space) too small, this could disturb the print image or cause the printhead
to scour the surface of some types of media. If the printhead scours the surface of the media, adjust the
height of the printhead.
• Cut Speed
This selects the auto cut speed.
Setting Details
Printer Default The settings of the printer operating panel are applied.
Fast Select this setting if cutting with the Standard setting is not clean.
Standard Select this setting when you are not experiencing problems.
Slow Select this setting if cutting with the Standard setting is not clean.
Windows Software > HDI Driver >
iPF750 Paper Detailed Settings
3
385