Canon imagePROGRAF iPF750 MFP M40 - Manual (Page 690)

Paper Menu
Setting Item Description, Instructions
Load Paper Select sheets or rolls and load the paper.
Eject Paper Choose this item before removing loaded paper.
Chg. Paper Type (*1 →P.675 ) Change the type of paper loaded. (See "Changing the Type
of Paper.")
→P.583
Chg. Paper Size Change the size of paper loaded. (See "Specifying the Paper
Length.")
→P.585 (See "Paper Sizes.") →P.569
ManageRemainRoll Choose On to print a barcode at the end of a roll before you
remove it. The printed barcode can be used in managing the
amount of roll paper left. Choose Off if you prefer not to print
the barcode.
(See "Keeping Track of the Amount of Roll Paper Left.")
→P.591
Paper Details (The type of pa-
per is displayed
here.)
(*1
→P.675 )
Head Height Adjust the Printhead height. (See "Troubleshooting Paper
Abrasion and Blurry Images (Head Height).")
→P.626
Skew Check
Lv. If you print on Japanese paper (washi) or other handmade pa-
per that has an irregular width, choose Loose for a higher
skew detection threshold, or choose Off to disable skew de-
tection. However, if paper is loaded askew when detection is
Off, note that paper jams or Platen soiling may occur.
Cutting Mode Specify whether or not to cut with the standard round-bladed
cutter.
Choose Automatic to have the roll cut automatically after
printing. If you choose Manual, the paper will not be cut after
printing. Instead, a line will be printed at the cut position.
Choose Eject if you prefer not to have documents dropped
immediately after printing, as when waiting for ink to dry.
Cut Speed Choose the cutting speed. If you use adhesive paper, choosing
Slow helps prevent adhesive from sticking to the cutter and
keeps the cutter sharp.
Trim Edge
First If a roll is loaded, the end of the paper will be cut.
CutDustRe-
duct. If you choose On, a line will be printed at the cut position
when paper cutting is selected. This option reduces the
amount of debris given off after cutting. It also helps prevent
adhesive from sticking to the cutter and keeps the cutter sharp
if you use adhesive paper. (See "Reducing Dust from Cut-
ting Rolls.")
→P.601
Vac-
uumStrngth Specify the level of suction that holds paper against the Plat-
en. (See "Adjusting the Vacuum Strength (Vac-
uumStrngth).")
→P.636
Control Panel > Printer Menu >
Menu Settings iPF750
8
674