Avocent CCM4850 - Manual (Page 31)

Chapter 3: Operations 19
To enable both Telnet and SSH connections:
Issue a Server Security command, indicating Encrypt=SSH,None.
CLI mode
While you are connected to an attached serial device, you may enter Telnet CLI mode and enter
CCM appliance commands.
To enter or exit CLI mode when connected to a serial device:
1. To enter CLI mode, type the CLI access character, which is Ctrl-D by default. At the CLI
prompt (>), you may enter CCM commands.
2. To exit CLI mode and return to the session with the attached device, issue a Resume command.
RESUME
For more information, see Resume Command on page 48.
To change the CLI access character:
Issue a Server CLI command or a Port Set command, using the Char parameter to specify the CLI
access character.
SERVER CLI CHAR=^<char>
- or -
PORT SET CHAR=^<char>
If you issue a Port Set command with Char=None, then the CLI access character specified in the
Server CLI command will be used. You may use the Port Set command to override the Server CLI
access character on a per-port basis.
For more information, see Server CLI command on page 49 and Port Set command on page 45.
To display CLI access character information:
Issue a Show Server CLI command.
SHOW SERVER CLI
For more information, see Show Server CLI command on page 61.
Ending Device Sessions
To end your session:
Enter CLI mode and issue a Quit command.
QUIT
- or -
If you initiated the device session with a Connect command, enter CLI mode and issue a
Disconnect command.