Avocent CCM4850 - Manual (Page 64)

52 CCM4850 Installer/User Guide
Examples
The following command enables the PPP server with a local IP address of 192.168.0.1, a remote IP
address of 192.168.0.2 and a subnet mask of 255.255.255.0.
> ser ppp ena loc=192.168.0.1 rem=192.168.0.2 mas=255.255.255.0
The following command enables the PPP server with previously configured IP and subnet mask
values. This form of the command would not be valid unless the IP and subnet mask values had
been previously configured.
> server ppp enable
Server RADIUS command
The Server RADIUS command defines or deletes RADIUS parameters for the CCM RADIUS
client. For more information, see RADIUS authentication on page 23.
When you enter this command, you are prompted to confirm or cancel the specified changes.
Access right: SCON
Access level: APPLIANCEADMIN
Syntax
SERVER RADIUS PRIMARY|SECONDARY
IP=<radius_ip> SECRET=<secret> USER-RIGHTS=<attr>
[AUTHPORT=<udp>] [TIMEOUT=<time-out>] [RETRIES=<retry>]
- or -
SERVER RADIUS PRIMARY|SECONDARY DELETE
REMOTEIP=<rem_ip>
IP address to assign to the PPP client end of the PPP connection. Must be on same
subnet as LOCALIP address.
MASK=<subnet> Subnet mask for the PPP dial-in client.
Table 5.12: Server PPP Command Parameters (Continued)
Parameter Description
Table 5.13: Server RADIUS Command Parameters
Parameter Description
PRIMARY|
SECONDARY Indicates either the primary RADIUS server or the secondary RADIUS server is
being defined or deleted.
IP=<radius_ip> IP address of the RADIUS authentication server.
SECRET=<secret>
8-24 character text string for shared secret with the RADIUS server. Enclose the
string in quotes if it contains spaces.
USER-RIGHTS=<attr> Attribute number defined on the RADIUS server, in the range 1-255.