User unlock command – Avocent CCM4850 User Manual

Page 80

Advertising
background image

68 CCM4850 Installer/User Guide

Examples

The following command sets the access rights for JohnDoe, enabling access to all ports with
configuration and monitoring access rights.

>user set JohnDoe access=pall,scon,smon

The following command removes the server configuration access right for JohnDoe, and leaves
other access rights intact.

> user set JohnDoe access=-SCON

The following command deletes the SSH key information for JohnDoe. The command will
complete successfully only if JohnDoe has a password configured in a previous User Add or User
Set command, and if there are other users with User access rights.

> user set key=“”

User Unlock command

The User Unlock command unlocks a user who was previously locked-out. After this command
completes, the user will be able to attempt login authentication again.
Access right: USER
Access level: ADMIN (may unlock all except APPLIANCEADMIN) or APPLIANCEADMIN

KEY=<sshkey>

Uuencoded SSH key. To delete an SSH key (whether it was originally specified with
the SSHKEY and FTPIP parameters or with the KEY parameter), specify Key=“”.

ACCESS=<access>

Command and port access rights or level. You may specify multiple access rights,
separated by commas, or a level. If specifying access rights, you may use one of
three forms:
ACCESS=<access> to specify all access rights.
ACCESS=+<access> to specify only access rights to be added.
ACCESS=–<access> to specify only access rights to be deleted.
Valid values for access rights are:
P<n>

Access to the specified port number.

P<x-y>

Access to the specified range of ports.

PALL

Access to all ports.

USER

User configuration access rights.

PCON

Port configuration access rights.

SCON

Configuration access rights.

SMON

Monitor access rights.

BREAK

Can issue Port Break command.

Valid values for access levels are:
ADMIN

PALL, USER, SMON, PCON and BREAK access rights.

APPLIANCEADMIN

PALL, USER, SCON, SMON, PCON and BREAK
access rights.

Default = PALL,SMON

Table 5.36: User Set Command Parameters (Continued)

Parameter

Description

Advertising