Avocent CCM4850 - Manual (Page 63)

Chapter 5: CCM Appliance Commands 51
Syntax
SERVER FLASH BOOT|APP HOSTIP=<tftp_add> IMAGE=<host_file>
Example
The following command updates the boot image program using the image file name
c:\winnt\system32\drivers\ccm50bt.img, which is located on the TFTP server host located at
192.168.1.16.
> ser fla app hostip=192.168.1.16
c:\winnt\system32\drivers\ima=ccm50bt.img
Server PPP command
The Server PPP command enables or disables the PPP server on the console port. For more
information and requirements, see Connecting to devices using PPP on page 15 and Configuring
and using dial-in connections on page 14.
Once the PPP server has been configured with this command by specifying the required addresses
and masks, those values remain in the database. Later, if you disable the PPP server and wish to
reenable it with the same addresses, you don’t need to specify the address values again.
When you enter this command, you are prompted to confirm or cancel the specified changes.
Access right: SCON
Access level: APPLIANCEADMIN
Syntax
SERVER PPP DISABLE|ENABLE
[LOCALIP=<local_ip>] [REMOTEIP=<rem_ip>] [MASK=<subnet>]
Table 5.11: Server FLASH Command Parameters
Parameter Description
BOOT|APP
Indicates either the boot image should be updated or the application image should
be updated.
HOSTIP=<tftp_add> IP address of TFTP server host.
IMAGE=<host_file> Name of file on TFTP server host containing the image file.
Table 5.12: Server PPP Command Parameters
Parameter Description
DISABLE|ENABLE Disables or enables the PPP server.
LOCALIP=<local_ip>
IP address to be used to connect the CCM appliance over the PPP connection. Must
be on same subnet as REMOTEIP address.