Avocent CCM4850 - Manual (Page 61)

Chapter 5: CCM Appliance Commands 49
Server CLI command
The Server CLI command:
•
Specifies the console port type
• Specifies the CLI access character
• Enables or disables device connection from the console port
• Specifies a modem initialization string
• Specifies port history mode operations
• Specifies a port time-out value
At least one parameter must be specified.
Access right: SCON
Access level: APPLIANCEADMIN
Syntax
SERVER CLI [TYPE=<type>] [CHAR=^<char>] [CONNECT=ON|OFF]
[HISTORY=HOLD|AUTO,CLEAR|KEEP] [MODEMINIT=“<string>”]
[TIMEOUT=<time-out>]
Server SNMP Trap Enables/disables SNMP traps.
Server SNMP Trap
Destination
Defines/deletes destinations for enabled SNMP traps.
Server SSH
Enables/disables SSH session access to the CCM appliance and specifies the
SSH authentication method.
Table 5.9: Server Command Summary (Continued)
Command Description
Table 5.10: Server CLI Command Parameters
Parameter Description
TYPE=<type>
Terminal type to be used on the console port. The entire name of the type must
be specified; abbreviations are not permitted. Valid types are: ASCII, VT52,
VT100, VT102, VT220 and VT320.
Default: ASCII
CHAR=^<char>
CLI access character in the range A through _ (underscore). (The allowable
ASCII range is 0x41-0x5F and 0x61-0x7A.) The CLI access character, when
pressed simultaneously with the
Ctrl key during a session with an attached
serial device, will suspend the session with the device and place you in CLI
command mode. This value will be used if a port’s Port Set command contains a
Char=None parameter.
Default = ^d