HP Designjet T1100 MFP series User Manual
Page 147
Advertising
10.
Slide the new cutter into position on the cutter rail.
The two wheels on the bottom of the cutter should engage the central ridge on the cutter rail, and
the two bushing guides should fit into the groove in the upper part of the cutter rail.
Check that the cutter runs smoothly up and down the rail. You can leave it anywhere on the rail;
the printer will park it correctly later.
ENWW
Replace the cutter 135
M
ainta
in
in
g the printer
Advertising
This manual is related to the following products: