HP Designjet T1100 MFP series User Manual
Page 148
Advertising
11.
Fit the cutter stop onto the end of the cutter rail, holding it there with one hand while you tighten
the screw with the screwdriver in your other hand.
12.
Put the left end cover back on the printer, aligning the protrusions with the holes in the printer.
13.
Close the ink cartridge cover.
14.
At the front panel, turn the printer back on. The printer checks that the cutter has been correctly
installed. Look at the front panel and follow its instructions if there is any problem.
136 Chapter 12 Maintaining the printer
ENWW
Maint
aining t
h
e printer
Advertising
This manual is related to the following products: