HP Designjet T1100 MFP series - Manual (Page 58)

2. Rest the blue end of the spindle on the right side roll holder.
3. With both hands, push the spindle into both roll holders at the same time. The spindle snaps into
place.
4. If the edge of the roll is not straight or torn (sometimes due to tape used to hold end of the roll),
pull paper slightly beyond the cutting groove and use a cutter to cut a straight edge.
TIP: Cut the paper as straight as possible, as uneven paper does not load correctly.
46 Chapter 5 Paper handling ENWW
P
ape
r ha
ndl
ing