A&D FX-i SERIES - Manual (Page 53)

51
15. COMMANDS
15-1 Command List
Note
A command has a terminator added, that is specified using the "Terminator (
Crlf)"
parameter of “Serial interface (
5if )” in the function table, and is sent to the balance.
Commands to query weight data
C Cancels the S or SIR command.
Q Requests the weight data immediately.
S Requests the weight data when stabilized.
SI Requests the weight data immediately.
SIR Requests the weight data continuously.
E
SC P Requests the weight data when stabilized.
Note: The “Q” and “SI” commands, the “S” and “
E
SC P” commands behave the same.
Commands to control the balance
CAL Same as the CAL key.
OFF Turns the display off.
ON Turns the display on.
P Same as the ON:OFF key
PRT Same as the PRINT key
R Same as the RE-ZERO key
SMP Same as the SAMPLE key.
T Tare key
Z Same as the RE-ZERO key
E
SC T Same as the RE-ZERO key
U Same as the MODE key
?ID Requests the ID number.
?SN Requests the serial number.
?TN Requests the model name.
?PT Requests the tare weight.
PT:
∗∗∗∗∗. ∗ g Changes the tare weight.
The unit added is the current weighing unit in A&D standard format.
Note: The “R”, “Z” and “
E
SC T” commands behave the same.
E
SC : ASCII code 1Bh