HP Photosmart C7200 Series - Manual (Page 198)

Solution: Change the Paper Type setting to match the type of paper loaded in the
input tray.
For more information, see:
• “Set the copy paper type” on page 123
• “Set the paper type for printing” on page 85
Cause: The copy or print paper type setting is incorrect.
Solution: Load high-quality paper in the input tray and print the image with a high
print quality setting, such as Best, Maximum dpi, or High Resolution. Always make
sure the paper you are printing on is flat. For best results when printing images, use
HP Premium Plus Photo Paper.
If the problem persists, use the software you installed with the HP All-in-One or
another software application to rotate your image 180 degrees so that the light blue,
gray, or brown hues in your image do not print at the bottom of the page.
For more information, see:
“Information on paper” on page 171
Cause: You are printing on the wrong side of the paper.
Solution: Load paper with the side you want to print on facing down. For example,
if you are loading glossy photo paper, load the paper with the glossy side down.
For more information, see:
“Load paper” on page 76
Cause: The fax sender is using a low resolution or the original was poor quality.
Solution: Ask the sender to increase the resolution and to verify the quality of the
original.
Printouts have vertical streaks
Cause: The paper type is not suitable for the HP All-in-One.
Solution: Use HP Premium Papers or any other paper type that is appropriate for
the HP All-in-One.
Cause: The glass or automatic document feeder of the sending fax machine is dirty.
Solution: If you have vertical lines or streaks on the fax, the sender's fax machine
might have dirt or dust on the glass or automatic document feeder. Check with the
sender to see if the glass or automatic document feeder is clean.
Printouts are slanted or skewed
Cause: The paper is not feeding properly or is loaded incorrectly.
Print quality troubleshooting 197
Trou
bles
ho
ot
ing